Hair Weft fitting instructions

How to wear clip in Hair Wefts

	1. Move the tail comb or your index fingers under the hair and along the scalp until the hair is separated from the right to the left hairline.
	2. Section your hair. Clip-in weft extensions should be attached from the bottom up. Starting at the lowest point on the hairline, and using a tail comb or your index fingers, creates a part where you wish to section off the hair.
	3. Clip up the hair above the part. Lift up all the hair above the part and clip it out of the way.
	4. Prepare the first weft cut your metre length so that the weft is wide enough to sit along back of your hair line. Then open all the snap clips so they are ready to be inserted into your hair.
	5. Placement of the first weft. The clips should be placed on your own hair below the part so that the top of the weft is even with the part.
	6. Placement of the first clip. The middle clip should be place first by locating at the middle of the nape. Place the clip on your hair just below the part. Moving the clip downward, catch your hair in the clip and snap it shut.
	7. Placement of the second clip. The right clip is next. Holding the middle clip in place with your left hand, use your right hand to move the right edge of the weft as far as it will go around your head. As above, place the clip on your hair just below the part, and moving the clip downward, catch your hair in the clip and snap it shut.
	8. Check for gaps. Now that all three clips are attached, run your fingers along the weft to make sure it lies flat against your head along the entire width. If there are any gaps, correct this by snapping the clip open, lifting it off hair and repositioning it so that the weft lies flat.
	9. Preparing to place the second weft. This weft will be placed above the first weft. Release all the hair that was clipped out of the way in step six. Then, slightly above the weft that was just attached, make another part-as explained in steps 1 through 5.
	10. Placing the second weft. Repeating steps 5-7, attach the next weft. To complete a style, follow steps 1-8 for each weft attached.
	11. If you have cut your wefts to be worn on the sides too take the right clip. Holding the middle clip in place with your left hand, use your right hand to move the right edge of the weft as far as it will go around your head. As above, place the clip on your hair just below the part, and moving the clip downward, catch your hair in the clip and snap it shut.
	12. Removing the hair wefts. To remove a weft, snap open all the clips and gently lift up and away from your hair. Never try to remove a weft without first opening all the clips. Pulling or tugging to remove a weft can result in damage to your own hair.